Question about DxLab Commander NOT communicating with Flex 6700 since Smart SDR upgrade to v1.9.7.

  • 1
  • Question
  • Updated 3 years ago
  • Answered

I have been using the DxLab Suite with my new Flex 6700 and all has been working beautifully  using SmartSDR version 1.8.4.  I upgraded to SmartSDR version 1.9.7 and now when I open DxLab Commander I get the message:

 “Can’t connect to FlexRadio SDR-6700:  No response from any network”

 Commander shows 0.0 in the Frequency window now.

 The DxLab Suite is on the same computer as SmartSDR.  The 6700 is on the same network:

 Commander Setup is unchanged. 

Computer IP:    192.168.1.4

Flex 6700 IP:   192.168.1.254  Static IP for radio

 

Any ideas or similar experience?

 

Jim, W4TE

Photo of Jim--W4TE

Jim--W4TE

  • 6 Posts
  • 1 Reply Like

Posted 3 years ago

  • 1
Photo of Jim--W4TE

Jim--W4TE

  • 6 Posts
  • 1 Reply Like
Official Response
All is well now.  I went back to DHCP instead of a static IP address for the 6700 and now I am communicating with Commander appropriately.  Thanks for everyone's suggestions.  I have been busy this week and have not turned on the computer and radio for several days and now all works well.  A pleasant surprise!
(Edited)