QSX on spot causes 6700 toRX on TX freq

  • 1
  • Question
  • Updated 2 years ago
Using HRD DX Cluster spot with 6700 and when a spot contains a QSX, my 6700 goes to the QSX freq and not the DX freq... I have two slices open but all that does is cause the B slice to move 1KC up from the QSX freq..My IC781 has no problem with it and loads both freqs. and puts the TX on the QSX freq... What am I missing??
Photo of Bruce Croskey

Bruce Croskey

  • 1 Post
  • 0 Reply Likes

Posted 2 years ago

  • 1
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9198 Posts
  • 3558 Reply Likes
I suspect that the slice is being tuned to the frequency that HRD has instructed it via a CAT command.  I also suspect that HRD is not putting the radio into split mode, so the radio is in simplex mode.  Simply opening a 2nd slice does not put the radio into split mode; the ZZSW command has to be issued by HRD to put the radio into split mode and to take it out when it is done.