QSK on 6700

  • 1
  • Question
  • Updated 3 years ago
  • Answered
  • (Edited)



From my post on the Yahoo Groups FlexRadioSmartSDR Group:


What does it take to shut off QSK on the 6700?  I thought any delay setting on the cwx panel would automatically shut off the QSK indicator in the slice.  I don't see that happening on ver 1,7 firmware even with a delay setting of 270.    With 0 delay I also get popping between characters like Greg mentioned on the Flec Community reflector when describing his  QSK  problems 2 years ago.

Did I miss a cw memo regarding this?

Regards

  Larry k1UO

Photo of K1UO - Larry

K1UO - Larry

  • 816 Posts
  • 131 Reply Likes

Posted 3 years ago

  • 1
Photo of Gerald - K5SDR

Gerald - K5SDR, Employee

  • 814 Posts
  • 1465 Reply Likes
Official Response
Lou is correct that it is always enabled if ANT1 or ANT2 are selected as the transmit antenna.  This is so the PIN diode does the switching instead of a mechanical relay.