Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

PTT Outputs RCA, Pin11 - I am lost

Steve B.
Steve B. Member ✭✭
edited September 2015 in FLEX-6000 Signature Series
Have a 6300 - looking to have PTT out cause a pixel to **** the power to it's pre-amp.  I almost understand .. but .. not quite.
On the FLEX-6700 and FLEX-6500 there are four PTT outputs. Three are RCA jacks on the rear panel, labeled TX1, TX2, and TX3. The FLEX-6300 has one RCA jack labeled TX. On each of the radios there is an output on Pin 11 of the Accessory connector on the rear panel as well. These outputs are isolated, and each one can have a specific delay. Some users will want to utilize the delay settings to sequence switch external equipment. 
So, on the 6300 there is an RX labeled TX .. can I use this or not?  Since SmartSDR can only configure Accessory (Pin 11), will RCA still be high on PPT or?

Steve


Answers

  • Steve N4LQ
    Steve N4LQ Member ✭✭
    edited September 2015
    If you plug your RCA cable into the TX RCA jack on the 6300 and plug the other end into your Pixel RCA Jack then under "settings/transmit" enable RCA TX1, it will key the Pixel unit off and on as you key the radio and protect the Pixel's amplifier from overload. Of course you will hear the relay clicking.
    Same goes for Pin 11 if you enable ACC TX. They are one and the same on the 6300 so you can control only one device at a time without adding external switching of some kind.
    Before make the connection you can try shorting the Pixel's RCA jack to ground and see if its relay activates. You'll hear it. 
    I take no responsibility for anything bad that happens. 
    Steve 

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.