Problems with WSJT-X

  • 1
  • Question
  • Updated 7 months ago
I'm unable to get my flex 6300 to work correctly with WSJT-X. I am using slicemaster and everything is configured correctly. For the past week I have been trouble shooting why it won't work. I am able to use it to send wspr it works fine. It shows recieve and says decode but, nothing shows up in the panel on the left side. I am running meinberg for time sync. Any ideas? Thanks in advance and 73's. K0SWT
Photo of K0SWT

K0SWT

  • 8 Posts
  • 0 Reply Likes

Posted 7 months ago

  • 1
Photo of Neil D Friedman N3DF

Neil D Friedman N3DF

  • 247 Posts
  • 79 Reply Likes
What version of WSJT-X?
Photo of K0SWT

K0SWT

  • 8 Posts
  • 0 Reply Likes
That was the problem. I uninstalled and loaded the updated version. Thanks all.
Photo of AH0U

AH0U

  • 352 Posts
  • 52 Reply Likes
Can you see the green bar graph on the left side of WSJT and if so does it bounce up and down???
Photo of K0SWT

K0SWT

  • 8 Posts
  • 0 Reply Likes
Yes it does.
Photo of Danny K5CG

Danny K5CG

  • 387 Posts
  • 61 Reply Likes
Do you have CAT control setup with WSJT-X such that when you select a band from the drop down control in WSJT-X, it changes the frequency of the Flex?

More often than not with digital modes, the radio is simply not tuned to the correct spot.
Photo of Craig - KØCF

Craig - KØCF

  • 209 Posts
  • 74 Reply Likes
I repeat N3DF's question: What version of WSJT-X are you running? If it is not 2.0, you will likely see nothing decoded because the specification changed with v 2.0 and it is NOT compatible with older versions.
Photo of K0SWT

K0SWT

  • 8 Posts
  • 0 Reply Likes
I updated to 2.0 and it is working fine now. Thanks all.