Problem switching between RX antenna ports

  • 1
  • Problem
  • Updated 5 years ago
  • Acknowledged
Listening to a weak station in E51 this morning on 160 with RX array on RXB of the 6700. Then switched to the small antenna I had on RXA to compare signals but when I switched back to RXB the signal was gone and I noticed the noise floor had gone up as if the attenuator had been switched in. I had to go to the RF Gain slider and move that ( just off where it was and back again) to bring back the proper level for the RXB port. Repeatable every time. Maybe this has already been reported?
Using Ver1.0.0
Photo of K1UO - Larry

K1UO - Larry

  • 816 Posts
  • 131 Reply Likes

Posted 5 years ago

  • 1
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9152 Posts
  • 3478 Reply Likes
Official Response
We have entered this issue into our bug tracker for further analysis. Thanks for the report