Problem with TX profiles for my SO2R setup

  • 1
  • Question
  • Updated 12 months ago
I have replaced my 6500 with a 6600M and I'm trying to get SO2R set up. I'm using the same connection cable for PTT (ACC TX). I'm running SSDR 2.4.9. I'm using a 4O3A 2x8 Antenna Genius that allows me to connect either ANT1 or ANT2 to any of 8 antennas. I have set up 2 slices, A and B and I want slice A to always be associated with the SO2R_TX1 profile and slice B to always be associated with the SO2R_TX2 profile, but this doesn't work. It seems that these TX profiles are associated with the band selection. So, if slice A is on 20m using ANT1 for both TX and RX and slice B is on 40m using ANT2 for both TX and RX, then I move slice A to another band, say 80m and move slice B to 20m where slice A was previously, slice B defaults to ANT1 for both TX and RX. I want it to retain its association with ANT2. This way, I can set either slice to any band and keep the slice associated with a fixed antenna selection (ANT1 or ANT2 for both TX and RX). Is this possible? 

73, Les VE3NNT
Photo of Les Brown

Les Brown

  • 21 Posts
  • 0 Reply Likes

Posted 12 months ago

  • 1

Be the first to post a reply!