Pop out window slider

  • 1
  • Question
  • Updated 4 months ago
  • (Edited)
Has anyone experienced a problem with a pop out Radio window panel? Sometimes when I try to grab the slider with the mouse to adjust it, when I move the mouse the entire pop out window moves rather than the slider. This is with SSDR 2.0.17
Photo of Mark Erbaugh

Mark Erbaugh

  • 379 Posts
  • 34 Reply Likes

Posted 10 months ago

  • 1
Photo of Bill W2PKY

Bill W2PKY

  • 448 Posts
  • 78 Reply Likes
What slider??
Photo of Mark Erbaugh

Mark Erbaugh

  • 379 Posts
  • 34 Reply Likes
The volume slider in the RX panel
Photo of Ken - NM9P

Ken - NM9P, Elmer

  • 3916 Posts
  • 1190 Reply Likes
Yes, I have noticed this, too.  When the panel is popped out, you must be more careful when grabbing any of the slider controls, because if you miss, you drag the whole panel around the screen.

Ken - NM9P
(Edited)
Photo of Elliot Skultin

Elliot Skultin

  • 31 Posts
  • 13 Reply Likes
Antenna gain sliders are extremely difficult to grab and do not always work. The locator dot does not connect with the slider graphic. I believe the pop out is too crowded and it is interfering with another object. Flex 6400M
(Edited)
Photo of Ken - NM9P

Ken - NM9P, Elmer

  • 3916 Posts
  • 1190 Reply Likes
In more recent versions, at least, it isn’t necessary to grab and drag the antenna gain slider. You can move them by clicking to the left or right and it will pop a step that direction for each click.
Photo of Elliot Skultin

Elliot Skultin

  • 31 Posts
  • 13 Reply Likes
Sounds nice but the 6400M does not support a mouse. Clicking is with a fingertip and it works about 10% of the time.  Basically i frantically tap at the extremes of the slider hoping to jog it to the right and occasionally it works.
Photo of Ken - NM9P

Ken - NM9P, Elmer

  • 3916 Posts
  • 1190 Reply Likes
I can see how that would be frustrating...

You might want to report this in a new thread, because it may be a different issue related to the "M" series touch panel software.

The original thread here was related to "interesting" behavior when a panadapter or TX control panel was "popped out."
Photo of Ken - NM9P

Ken - NM9P, Elmer

  • 3916 Posts
  • 1190 Reply Likes
Oops...I see that you already did!

Have a wonderful day!
Photo of Elliot Skultin

Elliot Skultin

  • 31 Posts
  • 13 Reply Likes
You too!  I appreciate your contributions to this group.  Other than a few undocumented features, i absolutely love this rig!
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9130 Posts
  • 3454 Reply Likes
I would write this up as a defect, but you are on an old release of SmartSDR.
Photo of Elliot Skultin

Elliot Skultin

  • 31 Posts
  • 13 Reply Likes
OK.  I installed 2.2.1.287, then the latest one from Flex.  It automatically grabbed it when I connected to my switch.
(Edited)