Panadapter waveform below bottom of display

  • 1
  • Problem
  • Updated 5 years ago
  • Not a Problem
The panadapter waveform is below the screen on some frequencies just showing peaks on slice A. The waveform on slice B does not show up at all even on very strong signals. The scale on the right is all the way up on both channels.
Photo of Wade Brock

Wade Brock

  • 6 Posts
  • 0 Reply Likes

Posted 5 years ago

  • 1
Photo of Al K0VM

Al K0VM, Elmer

  • 573 Posts
  • 93 Reply Likes
Wade,
If you left-click-hold in the right edge of the panadapter ( where the dbm scale is ) you can slide the scale and the spectrunm up or down to fit you situation.. You can use the Up-down arrows at the top of that column to adjust the scale..

Hope this helps..

AL, K0VM
Photo of Ken - NM9P

Ken - NM9P, Elmer

  • 3916 Posts
  • 1189 Reply Likes
As you zoom in and out in the panadapter, the pan noise floor decreases and increases. the closer in you go, the lower the trace sinks. Grabbing and dragging the right hand scale will bring it back where you want it.
Photo of Wade Brock

Wade Brock

  • 6 Posts
  • 0 Reply Likes
Al and Ken,
Dragging the scale worked for A. B slice still doesn't display with -160 on the scale and a S9 signal. The receive works but with no display. I can't figure out what I am missing. Thanks for the help.
Wade
Photo of George Molnar, KF2T

George Molnar, KF2T, Elmer

  • 1542 Posts
  • 547 Reply Likes
Works here. I do notice that sometimes these weird little glitches (like not being able to access a function or feature) are resolved by power cycling the radio.
Photo of Michael - N5TGL

Michael - N5TGL

  • 307 Posts
  • 101 Reply Likes
Look at the top of the scale and you'll see two triangles, one pointing up, one pointing down. Click on the one pointing down until the scale collapses to where you can see what you're after.
Photo of W4YXU

W4YXU

  • 75 Posts
  • 5 Reply Likes
A suggestion for this topic: Make zoom in/out center on current baseline and frequency. I think this is what most are trying to do with zoom!
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9130 Posts
  • 3453 Reply Likes
This is a great conversation that's separate from the main topic, so I created a new idea topic to continue the discussion. Please reference the new topic here: Center Zoom capability
Photo of Wade Brock

Wade Brock

  • 6 Posts
  • 0 Reply Likes
The waveform is displaying now after shutting everything down and rebooting for the third time. I guess something wasn't getting loaded. Thanks to everyone for your help.
Wade Brock K4YSB