Only one DAX channel working on 6300

  • 1
  • Question
  • Updated 2 years ago
Suddenly, today, only one DAX channel will work... not DAX 1 and 1 at same time. I had both working well up until this afternoon.  I did have to do a  repair after a Windows update.  Since the repair did not change the single DAX situation I just did the SMARTSDR 1.9.9.1  upgrade hoping that would solve the problem but it does not.   I have made sure Dax 1 and DAX 2 are set correctly in slice  A  and B,  I have  configured digital software to have INPUT as DAX 1 and DAX , I have made sure the DX Control has two streams active with good RX levels .  I;ve re-booted a few times.  Stumped .
Andy K3UK
Photo of Andrew O'Brien

Andrew O'Brien

  • 379 Posts
  • 43 Reply Likes

Posted 2 years ago

  • 1
Photo of rich

rich

  • 37 Posts
  • 3 Reply Likes
Are you using Windows 10?  There was a recent full-blown update and, for me, wiped out some FlexVSP drivers.  
73, Rich, K3VAT
Photo of Andrew O'Brien

Andrew O'Brien

  • 379 Posts
  • 43 Reply Likes
Yes, I am using Win 10.  I got that update yesterday.  I thought it went OK, but perhaps I am wrong.  Andy K3UK