Noise Bursts Only on 20m only and when key down on CW - anyone ever seen this?

  • 1
  • Question
  • Updated 1 year ago
  • Answered
I recently installed SmartSDR v1.10.16.174 and  have never seen this before then, on 20m only if I hit the key the panadapter display jumps. I set the width to cover thru 30m and see these burst across the display yet when I switch to 30m band everything is fine.

Thank You
Ed K1EDG


Photo of Ed

Ed

  • 10 Posts
  • 0 Reply Likes

Posted 1 year ago

  • 1
Photo of Michael Aust

Michael Aust

  • 135 Posts
  • 32 Reply Likes
AGC Issues ?
Photo of Ed

Ed

  • 10 Posts
  • 0 Reply Likes
Thanks for your reply, Dudley at Flex found that the "weighted averaging" was on on 20m, turned it off and problem is gone...TU...Ed
Photo of Mark WS7M

Mark WS7M

  • 268 Posts
  • 74 Reply Likes
Do you have your Display -> Weighted Average turned on?  I had a similar look up and down the band with weighted average turned on.
Photo of Ed

Ed

  • 10 Posts
  • 0 Reply Likes
Thanks for your reply, Dudley at Flex found that the "weighted averaging" was on on 20m, turned it off and problem is gone, you were correct! Thanks 73..Ed...

This conversation is no longer open for comments or replies.