no transmit on 6500

  • 1
  • Question
  • Updated 6 years ago
  • Answered
On the Flex 6500
loaded up smartSDR for first time today .. receiver works apparently, but no output on transmit into dummy load. tuner works and indicates success, but speaking into mic indicates 20 watts and no more , even on AM
Photo of Kennth Blanton

Kennth Blanton

  • 3 Posts
  • 0 Reply Likes

Posted 6 years ago

  • 1
Photo of George Molnar, KF2T

George Molnar, KF2T, Elmer

  • 1679 Posts
  • 614 Reply Likes
In Tune mode, can you move the power to the right and see full power?
How about CW? What microphone are you using? In many cases, the +20db button needs to be pressed for full output - is the modulation meter fully deflecting?
By the way, I believe AM operation is not recommended at this time.

Good luck & welcome to the 6500 club!
Photo of Dave - WB5NHL

Dave - WB5NHL

  • 288 Posts
  • 67 Reply Likes
AM transmit isn't implemented in 0.13.10 software.

George is right, check the +20db button and slide the mic gain up.
Photo of Michael - N5TGL

Michael - N5TGL

  • 308 Posts
  • 103 Reply Likes
From page 6 of the 0.13.10 release notes:

"6. Only transmitting on USB/LSB and CW is supported. Do not transmit on AM"

Read the release notes. The radio you save may be your own. :)