In your transmit panel, next to the mic level controls, etc. do you have the DAX Button turned ON?
In the Transmit panel, are you seeing any deflection on the TX Audio level meter?
In the DAX Control Panel, are you seeing any deflection of the meter in DAX TX Audio?
You might need to check the appropriate sliders for those inputs....
Ken - NM9P
it is strange I did see that about 5 monitors heard my signal but it is not consistent; power is up to 50%; still no qso's
I assume that the tx bandwidth refers to the filter which is at 3k
when I enable tx in wsjt-x I see a elevation of the spectrum signal but still absolutely nothing on the meters
tried the mic and see that a signals shows on the level meter and on the spectrum but nothing on the rf or swr meters
thanks to all for your suggestions
Agree that is time to open a ticket?
1.On FT8 setup click (FILE) ->Settings->Frequencies
a) The USA is in Region 2 and the "Frequency Calibration" may need to be calibrated. My Flex- 6700 was off by 1,00Hz:
b) I found that it was hard to make contact until I move 1Hz up with the Radio VFO or by
adjusting the FT8->Tx 1Hz lower.
That solved my problems