No Power Out in DIGL/DIGU

  • 1
  • Problem
  • Updated 3 years ago
  • Solved
  • 1
I have been configuring WSJT-x the last few days and had it all worked just fine. Today I decided to make my first JT65 qso. I went to tune mode in WSJT and could not get any power out. From there I did all the DAX channel checks and SSDR checks to make sure everything was set right and it was. After much fooling around with software I started checking things with SSDR and found that I could not generate any power out in SSDR TUNE mode if the the mode was set to digu or digl. I can generate output in all other modes. Does anybody have any idea of what could be wrong. I have done power reset on radio and killed and reloaded all the software. Using Win 10 and SSDR 1.9.13. Flex 6700 radio....

Thanks and 73,
Harry
W0LS
Photo of Harry Williams

Harry Williams

  • 112 Posts
  • 8 Reply Likes

Posted 3 years ago

  • 1
3 years ago
Photo of Cal Spreitzer

Cal Spreitzer

  • 451 Posts
  • 115 Reply Likes
Official Response
If your trying to tune while running WSJT-X  make sure your Low Cut and High Cut are set correctly and your tuning somewhere within those settings.  I have my Low Cut = 0,  and High Cut=5000.  That way anywhere on the JT65/JT9 are of the waterfall I will have TX power.  DIGIU is always used.

Cal/N3CAL
(Edited)
  • 1

Powered by Get Satisfaction