I suddenly get no power out on WSJT--x (I don't either on JTDX)
But I get power out on CW, and SSB
I have checked the full configuration on WSJT, the DAX is correct, the RF power slider is correct on both ends, I use mode SSB (it worked 100% OK with that modebefore, so there is no reason for me to change that). I receive OK. The DAX on Smart SDR is blue, the DAX number is correct (1). When I do a tune with power set to 100, I do get a 100W tune out.
I just do not know where else to search, except here on the forum !
Thanks
73
Paul F6EXV
But I get power out on CW, and SSB
I have checked the full configuration on WSJT, the DAX is correct, the RF power slider is correct on both ends, I use mode SSB (it worked 100% OK with that modebefore, so there is no reason for me to change that). I receive OK. The DAX on Smart SDR is blue, the DAX number is correct (1). When I do a tune with power set to 100, I do get a 100W tune out.
I just do not know where else to search, except here on the forum !
Thanks
73
Paul F6EXV
Ken - NM9P, Elmer
BTW, I would recommend using DigU with digital modes rather than USB for several reasons.
1) It assures that TX EQ and PROC are disabled so they don't cause audio problems.
2) You can set up a Mic Profile for WSJT that is set for 0-3000 of 0-5000 TX bandwidth and DAX ON, and it will remember these settings.
3) Once you use your new WSJT Mic Profile on WSJT once, the rig will remember the profile and link it to the DigU mode whenever you use it, and will switch back to your regular Voice SSB profile when you go back to voice modes. No need to manually switch back and forth.
73
Ken - NM9P