Newly loaded Windows 10 not connecting with Flex 6500

  • 1
  • Question
  • Updated 2 years ago
  • Answered
My Windows 7 crashed. A teck guy said the hard drive had re-formatted and nothing could be read or recovered. He reloaded Windows 10. I downloaded the current v 1.10.1 and now DAX and SMARTSDR say "Radio Not Connected"  My 6500 loads up fast.  Just not communicating with Dell Inspiron.    Any suggestions and fixes appreciated: N5LN
Photo of Lee - N5LN

Lee - N5LN

  • 19 Posts
  • 5 Reply Likes
  • Frustrated.

Posted 2 years ago

  • 1
Photo of Jim Gilliam

Jim Gilliam

  • 920 Posts
  • 215 Reply Likes
Have you tried connecting to your router to verify the drivers for your Ethernet card is working?
Photo of Kevin

Kevin

  • 931 Posts
  • 271 Reply Likes
As this is a new installation on a new OS load I would start by checking the Windows firewall. Make sure inbound and outbound connections are permitted on the network your radio is hooked to. If your computer is not on the Internet a quick check is to disable the firewall.

Control Panel\System and Security\Windows Firewall\Allowed apps

I permit all the Flex stuff on both the private and public side.

Photo of Peter K1PGV

Peter K1PGV, Elmer

  • 543 Posts
  • 321 Reply Likes
Absolutely. On an IBM 360/75 when I was in school. Fast as hell, but super low capacity.

Unlike paper tape which was slow as hell, and super low capacity.

I liked punch cards. Handy for running small jobs. I miss them for note taking. I was thinking of having so,e printed just for nostalgia purposes.

Peter
K1PGV
Photo of Kevin

Kevin

  • 931 Posts
  • 271 Reply Likes
I worked on the Bunker Ramo (Trident?) style multi-platter drives. I mentioned "tach rods" above because of an incident I once had when aligning the heads of one of these drives. The OPS guy crashed the heads on a disk and then, just in case the screeching was coming from the disk and not the heads proceeded to try two other disks. It was a mess. Then to add injury to insult, I'm following along step by step to align the new heads I just installed. Well step by missed-step. I pushed the head block out onto the platter and, because I forgot to remove power to the voice coil, it did an immediate emergency retract. Not only did it rip off a chunk of finger but it shot the voice coil tach rod out the center of the unit, between my legs as I was bent over the unit and through the back of a cabinet which was part of the Honeywell main frame.

It was not my best day. Fortunately though, it was not my last day. I think I was promoted to a supervisor shortly after that just to keep me from hurting myself. Or others.

The good ole days.

Kev
Photo of Dave

Dave

  • 97 Posts
  • 13 Reply Likes
Some people miss the good old days. Me, I do not. Sorry, but give me my Dell OPTIPLEX 3 GHz dual quad with 4 gigabytes of memory hihi
Photo of KY6LA - Howard

KY6LA - Howard, Elmer

  • 3724 Posts
  • 1578 Reply Likes
Anyone remember programming with patch panels?
Photo of Peter K1PGV

Peter K1PGV, Elmer

  • 543 Posts
  • 321 Reply Likes
OK. No. Definitely before my time. Were you limited to some number of steps. Equal to the number of panels?. Or, how did it work?

K1PGV

This conversation is no longer open for comments or replies.