new version of 1.x SSDR?

  • 2
  • Question
  • Updated 3 years ago
  • Answered
A little while ago, there was a discussion about the 6700 'dropping' from the top spot in the Sherwood Ratings, and it was discovered that this was due to some deep, interior setting in the software that wasn't quite right.  I found that whole discussion fascinating -- including the bit where Gerald 'hinted' that the fix might be applicable to other versions (6500/6300) of SSDR firmware as well.  So, I'm just kind of checking in/wondering where that went and if we might be seeing a new version of SSDR 1.x before 2.x?

I know, I know, Tim -- you can't say anything FOR SURE until things move along the Alpha/Beta testing road a bit.  But maybe if you could comment on that specific issue and if it will be included in a new 1.x version?

Thanks.
Photo of VE7ATJ

VE7ATJ

  • 137 Posts
  • 24 Reply Likes

Posted 3 years ago

  • 2
Photo of Rick

Rick

  • 162 Posts
  • 21 Reply Likes
I too have been thinking about that much discussed issue and wondering if there was going to be a conclusion and a software fix.
Photo of James Del Principe

James Del Principe

  • 318 Posts
  • 46 Reply Likes
I think we would all like a response.  If this is a deficiency in the SW it needs to be corrected in a pre- 2.0 release.          Jim
Photo of Michael Henry

Michael Henry

  • 11 Posts
  • 4 Reply Likes
I think many of us would like to see the answer to this question.
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9200 Posts
  • 3561 Reply Likes
Official Response
TBD.  It may be in a 1.x release after SmartSDR v2.0 is released.
(Edited)