New to rtty and dm780 settup for xmit.

  • 1
  • Question
  • Updated 2 years ago
  • Answered
I am using a Flex 6300 with DM780 for winkeyer and PSK modes with no problem but never used rtty modes.  Can receive rtty signals in USB afsk mode on 20 m.  Trying to figure out the correct way to set up DM780 to xmit rtty signals correctly?  All help appreciated.
Photo of Jerry Wilk

Jerry Wilk

  • 58 Posts
  • 8 Reply Likes

Posted 2 years ago

  • 1
Photo of Mike Hoing

Mike Hoing

  • 243 Posts
  • 38 Reply Likes
If your psk is working just switch DM780 to RTTY as it sounds like you have and let it rip


Should work if psk was working


Mike

N9DFD
(Edited)
Photo of Rick Hadley - W0FG

Rick Hadley - W0FG

  • 554 Posts
  • 118 Reply Likes
Flex to RTTY setting, DM780 RTTY-45(AFSK), Reverse, same CAT/DAX settings you use for PSK, Save as a profile and you're good to go.  You will need to select "Reverse" each time you start DM780.  I haven't found a way to get it to save that parameter.
Photo of Jerry Wilk

Jerry Wilk

  • 58 Posts
  • 8 Reply Likes
Thanks for your replies.  I am a little confused as to the center frequency setting of 2210 and how it relates to the transmit frequency.  When I set DM780 cursor to the incoming rtty signal (i.e. like psk31) am I transmitting directly to that incoming signal or some offset? 
Photo of Jerry Wilk

Jerry Wilk

  • 58 Posts
  • 8 Reply Likes
I figured it out last night as how to use the center frequency set at 2210. 
Photo of Alex - DH2ID

Alex - DH2ID, Elmer

  • 878 Posts
  • 157 Reply Likes