N1MM Logger+ and FLDigi RTTY setup

  • 1
  • Question
  • Updated 3 years ago
  • (Edited)
I had a bit of trouble this weekend getting everything to work right.  I must be missing an offset setting somewhere.  When I click to tune in the panadapter everything was fine.  But if I clicked on the bandmap, the slice would first change to the spot frequency then jump off of it by the FLDIGI alignment frequency in Digitial Interface Window config.  My work around was to set this to zero.  But then, I had to click on the signal in the Fldigi window to get it to decode.  

I'm pretty sure I had all of this working properly a few months back, but must be missing something now.  I've read alot of the set up docs but I cant find a discussion about how to set the various offsets available in the different pieces of software.  Any suggestions?
Photo of K1DBO


  • 543 Posts
  • 112 Reply Likes

Posted 3 years ago

  • 1

Be the first to post a reply!