MultiPSK configuration issue using 6700

  • 1
  • Question
  • Updated 6 months ago
  • (Edited)

I’m having a problem getting MultiPSK working with my
6700.  I’m able to receive fine but have had no success with transmit.  I’m using DAX channel 1 for receive and transmit.  The problem isn’t with Smart SDR its in understanding the configuration of MultiPSK.  In MultiPSK, I have sound input set to DAX Audio RX1 and this is working fine.  However in sound output, DAX Audio TX1 (DAX TX audio) doesn’t show up.  The only other selection is a setting labeled “Same sound card as for the input.”   I’m reasonably sure I have SmartCAT settings set OK.  When I engage MultiPSK “Tune” the 6700 does go to transmit .

If you’ve successfully setup MultiPSK with your 6000 series radio, I sure would like to know what settings you’re using.

Thanks,

Kirk, K6KAR

Note:  I was finally able to get transmit to work but had to use DAX pair 7 which was the only pair that shows up in MultiPSK



Photo of Kirk, K6KAR

Kirk, K6KAR

  • 39 Posts
  • 6 Reply Likes

Posted 4 years ago

  • 1
Photo of Andrew O'Brien

Andrew O'Brien

  • 379 Posts
  • 43 Reply Likes
I have used Multipsk successfully with my 6300 .  DAX TX shows up in my list, 
Andy K3UK