Lost remote transmit audio when operating remotely on an iPad using Parallels Access

  • 1
  • Question
  • Updated 2 years ago
  • (Edited)
I am remotely controlling my 6700 using Parallels Access.. Everything was operating normally except that the transmit audio channel was very high and I had to turn the Flex mic gain down to almost zero (5 instead of 70).

In trying to track down the high mic level from the iPad I have lost it all together. Receive Audio is still ok. My PC default audio settings are:

Speaker - Parallels Access Sound Controller
Microphone - Parallels Access Sound Controller

It must be something I have done. I have tried to find out what it might be, but to no avail. Is there a missing fader I can't find? Is there some setting in Parallels that I have missed?

Any help would be much appreciated.

Thanks

Winston
Photo of Winston VK7WH

Winston VK7WH

  • 204 Posts
  • 32 Reply Likes

Posted 2 years ago

  • 1
Photo of KY6LA - Howard

KY6LA - Howard, Elmer

  • 3403 Posts
  • 1292 Reply Likes
You can control the parallels Mike level '

Control panel-- Sounds -- Recording Devices--Parallels Mike--Properties --Legels
Photo of Winston VK7WH

Winston VK7WH

  • 204 Posts
  • 32 Reply Likes
Thanks Howard, I'll investigate it further tomorrow.

73 Winston