Loss of audio

  • 1
  • Problem
  • Updated 6 months ago
After appx an hour use the audio cuts out. All else unchanged. A quick close and reopen of 1.11.12 returns screen to where it was and solves this very old problem for about another hour. Is just a repeatable ongoing irritation.

This is a basic FLEX installation with no CAT or DAX or extras. All Win7 power settings are set to NEVER. No other probs with either 1.11.12 or windows. Any ideas? TNX.
Photo of Dave - W6OVP

Dave - W6OVP

  • 221 Posts
  • 69 Reply Likes

Posted 6 months ago

  • 1
Photo of Michael Walker

Michael Walker, Employee

  • 366 Posts
  • 96 Reply Likes
Hi Dave

Can I suggest an idea of exporting all your profiles, resetting the radio and then re-importing your profiles as a test?

You didn't say, but I assume the audio is coming right from the radio since you aren't using DAX.  Can you also run DAX at the same time and see if the audio disappears on a DAX channel?

Mike
Photo of Dave - W6OVP

Dave - W6OVP

  • 221 Posts
  • 69 Reply Likes
TNX Mike I'll give that a try. The audio is coming out of the computer speakers on a Sony stereo monitor. Volume controlled via REMOTE and a FlexControl.
Photo of Dave - W6OVP

Dave - W6OVP

  • 221 Posts
  • 69 Reply Likes
Looks like the hard boot did it Mike. No repeat of the problem since. TNX.
Photo of Dave - W6OVP

Dave - W6OVP

  • 221 Posts
  • 69 Reply Likes
Oops, spoke too soon. Worked as it should all day yesterday, and for an hour today. Back to the drawing board...
Photo of Rick Hadley - W0FG

Rick Hadley - W0FG

  • 579 Posts
  • 121 Reply Likes
Go into Windows Device Manager and inspect your RealTek (or whatever) audio driver. It sounds like it’s being allowed to go to sleep. I’m pretty sure that’s not a part of the regular Windows power settings.