Log4OM and Flex 6400? I have OmniRig selected on Log4OM but where is OmniRig for the Flex 6400

  • 1
  • Question
  • Updated 3 months ago
I am a long time user of Log4OM and would like to use it with my new Flex 6400M. I have OmniRig selected in Log4 , Where do I find OmniRig in the Flex Software to Select OmniRig?
Photo of Andy

Andy

  • 30 Posts
  • 0 Reply Likes
  • Lost

Posted 3 months ago

  • 1
Photo of VE3DZP

VE3DZP

  • 26 Posts
  • 6 Reply Likes
Good morning Andy. I am not familiar with Log4OM but to the best of knowledge if you are running SmartSDR and SmartSDR Cat that Omnirig is not needed. Just have Smart CAT make your com port.
Photo of W5AP

W5AP

  • 85 Posts
  • 6 Reply Likes
Set up another  SmartSDR CAT port C (any unused port will do - go to SmartSDR Cat and click add at the bottom) - and set up that CAT port  in OmniRig.  
Photo of Andy

Andy

  • 30 Posts
  • 0 Reply Likes
Thank you VE3DZP and W5AP for your suggestions. Appreciate your help.
Do not see any other way to reply.
Andy ., W3LI