Is there a Memories channel configuration page for the 6500?

  • 1
  • Question
  • Updated 8 months ago
Is there a Memories channel configuration page for the 6500? I found one for the 1500 (http://kc.flexradio.com/Knowledgebase...). I am configuring a 2M transverter and cannot get the setup for the local repeaters. No problems with simplex.
Photo of David Hamm

David Hamm

  • 5 Posts
  • 0 Reply Likes

Posted 8 months ago

  • 1
Photo of Mike va3mw

Mike va3mw

  • 824 Posts
  • 195 Reply Likes
Hi David

Check the manual http://www.flexradio.com/downloads/smartsdr-software-user-guide-pdf/

Chapter 22 on page 93.

Does that help at all?

Mike 
Photo of David Hamm

David Hamm

  • 5 Posts
  • 0 Reply Likes
I've looked at that part of the manual and I got some of it figured out. I am not sure of the "step: and the "repeater offset" settings.  Will the Frequency on the display change to the offset frequency when the radio is keyed?
Photo of John - WA7UAR

John - WA7UAR

  • 82 Posts
  • 23 Reply Likes
That's what it did for me. TX displayed the offset and RX displays the repeater output frequency. 
Photo of David Hamm

David Hamm

  • 5 Posts
  • 0 Reply Likes
What are the values used in "step: and the "repeater offset" settings?
Photo of WA2SQQ

WA2SQQ

  • 377 Posts
  • 81 Reply Likes
If you were already tuned to the frequency all those settings will be imported when you save it
Photo of David Hamm

David Hamm

  • 5 Posts
  • 0 Reply Likes
I saved the frequency but it doesn't work. I must be overlooking something.

6 meters Fm work correctly. 

2 meters transverter bought on ebay does not work. http://www.ebay.com/itm/144-to-28-MHz-ASSEMBLED-TRANSVERTER-2meters-2m-144mhz-146mhz-VHF-UHF-Ham-Rad... d
(Edited)
Photo of David Hamm

David Hamm

  • 5 Posts
  • 0 Reply Likes
Now it's telling me that the transmit slice has not been selected.