Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?

SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

intermodulation distortion

Bill Carnett
Bill Carnett Member ✭✭
edited February 2017 in FLEX-6000 Signature Series
Today while operating on 6 meters I noticed considerable distortion from strong local stations.  These guys were strong but not terribly so.  Typically I could control it with use of my filters.  However hearing clicks and signal blocking (sorry that's not the proper engineering term) up to 8 khz away.  One guy had a bad signal, at least close by, but most were nice clean CW signals.  Yes I was using the pre-amplifier, but this was 6 meters and signals were weak.  Not sure there is anything else to do.  Never had this problem with my icom-756 pro III.  However, it absolutely could be something I am doing/not doing correctly with the Flexradio.  Any advice is welcome. 
73, Bill
AH6FC/7

Answers

  • Jim Gilliam
    Jim Gilliam Member ✭✭
    edited June 2015

    Did you have your Noise Blanker on?


    Jim, K6QE

  • Andrew VK5CV
    Andrew VK5CV Member ✭✭
    edited February 2017

    Bill,

    I have had horrible intermodulation once with a fractured centre conductor to PL259 centre pin solder joint. No effect on TX SWR etc. So check your feed line connections.

    Andrew


Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories