I'm Trying to set up N1MM+ Logging for my 6700, using the Flex "How To Guide" "EZ Start Setup for RTTY

  • 1
  • Problem
  • Updated 1 year ago
I'm Trying to set up N1MM+ Logging for my 6700, using the Flex "How To Guide" "EZ Start Setup for RTTY With N1MM+ for Flex-6000". After setting up the "Digital Modes" Tab, I get the Error Message shown in the included Screen Shot and I can not get past this point. Its late and I'm half way asleep but I can't figure what I'm doing wrong. So I thought I would throw it out to the community and ask for some help. Everything was going good till I got to this point.
Anybody got any Ideas.
Al,   N4AB
Photo of Al

Al

  • 160 Posts
  • 9 Reply Likes

Posted 1 year ago

  • 1
Photo of Ken - NM9P

Ken - NM9P, Elmer

  • 3875 Posts
  • 1181 Reply Likes
Go to the mode control tab. Something may be incorrect there. Probably the box that says to take the mode from the radio needs to be selected?