How to get the Woodbox Radio S-Meter working?

  • 1
  • Question
  • Updated 5 years ago
  • Answered
Keith Pawley

Here is how to get the S meter working;
Go to:http://www.woodboxradio.com/flex6000....
Look for the following S meter "BobSmeter-Flex" and download it (remember where you put it or downloaded to the desktop)
After downloading it - unzipped the file BobSmeter-Flex_v1
Open SmartCAT and set a pair of com/port i.e, 5-15
Look for BobSmeter file and run it
The meter comes up - set the meter port to 5 every thing else should work.
Make sure you check for handshake between the meter and SmartSDR CAT.
Finally open the folder and look for "BobSmeter executable file and it will show on your desk top.

Note: This topic was created from a reply on the The S-meter for SmartSDR is available. topic.
Photo of Ernest - W4EG

Ernest - W4EG

  • 594 Posts
  • 116 Reply Likes

Posted 5 years ago

  • 1
Photo of Keith Pawley

Keith Pawley

  • 30 Posts
  • 0 Reply Likes
Thank you very much it is now working
kind regards
Keith
M0PAW