How to select RCA TX2 for XVTR Keying, and avoid keing in other HF band.

  • 3
  • Question
  • Updated 3 years ago
  • Answered
Hi All!
I would like to have RCA TX2 keying my XVTR, only when in use. If I TX in  any other HF band , XVTR is also activated  and there is a big mess.
Please inform how to select exclusive keing of TX1 TX2 TX3 acording to the band in use.

TNX

William - PY2GN
  
Photo of William Schauff

William Schauff

  • 10 Posts
  • 1 Reply Like

Posted 3 years ago

  • 3
Photo of EA4GLI - 8P9EH - Salvador

EA4GLI - 8P9EH - Salvador

  • 1782 Posts
  • 547 Reply Likes
As far as I know it cannot be done. I have been asking for this feature for over a year.

At the very least I would like direct access buttons in the GUI for the TX, instead of having to go through menus to get to them to find out even if they are on or off. Similar to the way you can enable/disable FDX and you can see right away if it is on.

Working with an amp, a 144 amp and a 440 transverter will be easier if this feature was enabled.
(Edited)
Photo of David Livingston

David Livingston

  • 122 Posts
  • 28 Reply Likes
I would like o see this also....
Photo of Ken - NM9P

Ken - NM9P

  • 4239 Posts
  • 1351 Reply Likes
Can this be done via the new USB port utility? Perhaps using a bit cable.?
Photo of Larry - W8LLL

Larry - W8LLL

  • 532 Posts
  • 116 Reply Likes
Official Response

Create a transmit profile for each band with only the needed tx rca activated in each one.

transmit profiles are discussed at the 8:30 mark

https://www.youtube.com/watch?v=xAdz1GRbg9Y&t=5s 


(Edited)