how can I control transmit level over virtual cables when using remote

  • 1
  • Question
  • Updated 3 months ago
How can I control transmit level over  virtual cables (VAC) when using a remote computer. I'm in Florida and my 6700 is at home in Tennessee. I am trying to use WSJT-X remotely. I have audio and decoding coming in OK using virtual audio cables. But when going into transmit the audio drive from wsjt-x is overdriving the transmitter. How can I adjust the drive level either on the Flex side or the wsjt-x side of the VAC?.The level is way into the RED.
Al, N4AB
Photo of Al

Al

  • 164 Posts
  • 9 Reply Likes

Posted 3 months ago

  • 1
Photo of Dudley - WA5QPZ

Dudley - WA5QPZ, Elmer

  • 73 Posts
  • 11 Reply Likes
With version 2.3.9 ,  you still need a computer at the shack, to run digital  and remote using a remote control SW to that computer to go along with SmartSDR ,  or Maestro...    That's the recommended method.  DAX is not ready yet for remote running..  Using VAC remotely is another issue,  may take a lot of bandwidth.   Most would use the remote audio in TeamView to the station computer,  but better just running remote control to station computer letting DAX run on the station computer,  you are just controlling from remote location .    This may change in the future.. 

Dudley - WA5QPZ


Photo of Steven Linley

Steven Linley

  • 240 Posts
  • 27 Reply Likes
Use Remote Desktop, Real VNC, or Team Viewer. Run WSJT-x on your PC in the shack. Then you can use DAX