Has anyone configured a Flex 6500 to work with ALE

  • 2
  • Question
  • Updated 2 years ago
  • (Edited)
I am trying to configure MARS ALE to work with my 6500. I get it to work but the relays in the radio are clicking like crazy... It's not the antenna tuner as I have it shut off so I am guessing its the preselector. I have only run it for a few seconds as I don't think it can be good for the relays.

Is there a way to turn off the preselector? Say via CAT?

Once ALE locks I would like the Antenna Tuner to tune and the preselector to come back on... can this be done via CAT?

Any thoughts?

Photo of Steven Catani

Steven Catani

  • 24 Posts
  • 1 Reply Like

Posted 3 years ago

  • 2
Photo of Alex - DH2ID

Alex - DH2ID, Elmer

  • 999 Posts
  • 186 Reply Likes
MARS-ALE is in many ways similiar toPC-ALE , but has not been updated since 2008.
The last PC-ALE beta update has been in 2014.


Look at Tim's and Andrew's commentaries at the end.

I had PC-ALE working with my Flex-6k5 and the Kenwood settings, but found that it works
much better with my "old" ICOM IC-756pro and a microHAM DigiKeyer II.
Photo of Chuck - KJ6HT

Chuck - KJ6HT

  • 49 Posts
  • 9 Reply Likes
I have a commercial ALE radio now but the 6500 performed well for me with MARS-ALE. If you zoom the pan-adapter all the way out it will help minimize the relay activity as this puts the radio in "Wide" mode and minimizes pre-selector operation.  I found that using the MMI-RADIO commands will lead to much better results than using the stock Kenwood or Flex-3000/5000 pre-loaded setup. Make sure you use and understand the MMI_RADIO command scheme, this will greatly minimize the relay operation, pay special attention to QSS. QSS is short for Quiet Scan, it is acheived by a series of CAT commands that open a Slice B and set the TX flag on that slice when you start the scan. This causes the tuner to setup for the frequency chosen for slice B and stops it from operating on all of the frequencies that are being scanned on slice A. When it is time to transmit, the scanning stops, slice B is removed and the TX flag is now on slice A. The tuner immediately recalls for that channel and the radio transmits. It takes a bit more research and work but the MMI-RADIO setup is worth the time. There is a sample set of MMI-RADIO commands that are included with MARS-ALE. They happen to be for a Kenwood TS-480 so many of the commands can be used for the Flex 6XXX series. Regarding your questions,  there is no CAT control of the pre-selector that I am aware of. If you pre-tune all of the ALE frequencies and use the QSS scheme you should have great results.
Photo of David Salomon

David Salomon

  • 111 Posts
  • 26 Reply Likes
Chuck -

Do you have a set of MMI files for the Flex?  I've used MARS-ALE set up as Kenwood and as Flex.  While they both work OK, I've had to fiddle with the QRG settings to ensure mode is changed correctly outside the ham bans.  Also, for reasons unknown to me, the scanning speed is very inconsistent.  Sometimes it's as fast as set in MARS-ALE, and sometimes very slow (and it's not because it's hanging on received ALE).  If the MMI files work better and more consistently, I'd love to have them as a starting point.

73 - David, AG4F