Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Hardware guide indicates an antenna match unit in the 6700-R???

Mystery Ham
Mystery Ham Member
edited August 2019 in FLEX-6000 Signature Series
Question for the FLEX Meisters:

The "FLEX-6000-Hardware-Reference-Manual" does a good job differentiating the features in the 6700 and 6700-R, even though specifications are, annoyingly,  listed in the same column. However, page 14 of the reference manual does seem to imply the 6700-R has an internal Antenna Match Unit (Tuner).

If this is not an error, are there any plans to provide a software interface to manually adjust L and C in the antenna match unit?


Thanks for you attention and time,
Mystery Hamimage

Answers

  • Tim - W4TME
    Tim - W4TME Administrator, FlexRadio Employee admin
    edited August 2019
    That is a doc oversight.  The FLEX-6700R has no antenna matching circuitry.
  • Mystery Ham
    Mystery Ham Member
    edited August 2016
    A shame that it doesn't...  Given that it isn't a part 97 device you could likely incorporate a noise bridge or some very low power adjustable frequency source to match an antenna using an ultra low power antenna matching circuit (lower cost, wider range of L & C, smaller package as compared to the 6700)  Put two of them in, one for each antenna.

    Then you have a reason to put slider controls in SSDR and play with firmware... :-)

    On an end fed wire, when tuned, I saw 1 to 2 dB loss on some bands while others improved 5 to 8dB as compared to bypass.  That extra 5 to 8db could make a big difference with weak signal work.


    Thanks for the time...

    Mystery Ham

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.