Front panel led indications?

  • 1
  • Question
  • Updated 4 years ago
  • 1
Front panel LED switches from green(RCV) to Red (xmit) for only an instant on xmit. Should'nt it stay red during the entire xmit cycle?  
Photo of Reggie-k6xr

Reggie-k6xr

  • 413 Posts
  • 32 Reply Likes

Posted 4 years ago

  • 1
4 years ago
Photo of MH_Flexer

MH_Flexer

  • 65 Posts
  • 13 Reply Likes

According to the manual, this is correct.

6.6.1 Chart for Indicator Color Codes 

SOLID BRIGHT RED: Transmitting on PA


SOLID ORANGE: Transmitting on XVTR port with low power
SOLID DIM RED: Transmit engaged, but transmit interlocks are not ready. Refer to SmartSDR documentation for description of transmit interlocks.
SOLID PURPLE: Radio is performing a software update
SOLID GREEN: Radio is in receive mode
FLASHING RED: Flashing three blinks indicates radio software is not running
OFF: Radio turned off, oscillators are off.
FLASHING DIM PURPLE: Radio is performing a persistence database rest

2015-02-05T21:07:47+00:00
Photo of Reggie-k6xr

Reggie-k6xr

  • 413 Posts
  • 32 Reply Likes
it does not stay red while in xmit. just blinks once. it used to stay red while xmitting
2015-02-05T21:11:35+00:00
Photo of Reggie-k6xr

Reggie-k6xr

  • 413 Posts
  • 32 Reply Likes
I should have said in CW it does not stay on while sending. it will blink once when you start and they just stay green. in ssb it stays red the whole time while xmitting. I ust have something incorrect or misunderstand
2015-02-05T21:14:27+00:00
Photo of Reggie-k6xr

Reggie-k6xr

  • 413 Posts
  • 32 Reply Likes
OK! I think I found the problem! I moved the delay down to zero and when I transmit in cw it stays red! If I move the slider up for delay, then it will just blink red and then stay green while I'm transmitting. Maybe I just did not notice it before.
4 years ago
Photo of MH_Flexer

MH_Flexer

  • 65 Posts
  • 13 Reply Likes
Best shoot out a Help Desk call.
4 years ago
Photo of George Molnar, KF2T

George Molnar, KF2T, Elmer

  • 1612 Posts
  • 570 Reply Likes
May want to do a factory default reset on the radio, and/or shutdown with removal of power for a few minutes. Both can help clear a lot of odd states.
2015-02-05T21:43:46+00:00
Photo of K1FR

K1FR

  • 109 Posts
  • 9 Reply Likes
Think Tim has already entered this behavior into list for fixing.
73, Tom
K1FR
4 years ago
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9153 Posts
  • 3496 Reply Likes
We have been working on the LED illumination code for v1.4, so this particular issue may be fixed in the upcoming release.
  • 1

Powered by Get Satisfaction