Flex 6500 Vs 1.1.2 installation and then Timeout

  • 3
  • Problem
  • Updated 5 years ago
  • In Progress

After following the installation instructions for 1.1.2,  the radio chooser indicated that an update to the 6500 was needed and proceeded to update the radio.  At one point the 6500 was in calibration and stayed there for a few minutes and a Timeout indication was indicated on the display.  The red led was flashing also.   I cycled the radio and tried a restart and the same Timeout appeared after the calibration stalled.   I removed the power from the radio waited a few minutes and cycled the radio on and the calibration stalled and finally timed out.

Anyone have any ideas as to what might be happening here?


Charlie, WA3UTC

Photo of Charlie, WA3UTC

Charlie, WA3UTC

  • 26 Posts
  • 7 Reply Likes

Posted 5 years ago

  • 3
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9152 Posts
  • 3479 Reply Likes
Official Response
If anyone else is experiencing an issue similar to this one, please submit a HelpDesk support ticket for issue resolution.