Flex Control driver problem

  • 2
  • Problem
  • Updated 4 years ago
I'm running PowerSDR with my 5000 on an Intel i7 machine 8GB RAM W7 64bit. It's been running great for years. I recently purchased a Flex Control Knob. When the driver loads my mouse slows down to a crawl. At first I wasn't sure if it was the FC driver, so I removed the driver and the problem went away. After a day with no mouse problem I installed the Flex Control driver again, and the mouse slowed down again. I did try changing the COM port to COM30 and restarted, but the slow down persists. I have once again removed the driver and my mouse is working again. Any ideas will be greatly appreciated.
Photo of Paul - K6HR

Paul - K6HR

  • 75 Posts
  • 11 Reply Likes

Posted 4 years ago

  • 2
Photo of Ricky


  • 32 Posts
  • 4 Reply Likes
First if your using a USB hub this will happen. If not then simply try a different port. If that does not do it check to make sure they are not using IRQ in you computer.
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9152 Posts
  • 3478 Reply Likes
Is by chance your mouse a USB device?  If so then you are probably using the same USB controller for both.  Try moving the mouse to a different USB port.