Flex 6x00 and Micorham Station Master

  • 1
  • Question
  • Updated 11 months ago
Hi, i have a question i need to connect my Flex 6300 at my station master made from microham, i have build the cable but i don't know how to set properly the software, anyone can send me some screenshot of his configuration.
Many thanks bye bye
Photo of Lorenzo Mendini

Lorenzo Mendini

  • 16 Posts
  • 0 Reply Likes

Posted 11 months ago

  • 1
Photo of Don -  ik2egl -  ai4sd

Don - ik2egl - ai4sd

  • 82 Posts
  • 6 Reply Likes
ciao
the best approach to drive SM is by flex USB interface+(suggested) USB to Serial adpater
Photo of Lorenzo Mendini

Lorenzo Mendini

  • 16 Posts
  • 0 Reply Likes
Ok Don, please call me as soon as possible, many thanks.
Photo of Don -  ik2egl -  ai4sd

Don - ik2egl - ai4sd

  • 82 Posts
  • 6 Reply Likes
ok 
Photo of Lorenzo Mendini

Lorenzo Mendini

  • 16 Posts
  • 0 Reply Likes

anyone can confirm that the followed wiring diagram are correct?

Pin # Label Description


TIP TXD CAT DATA output from SM

RING1 RXD CAT DATA input to SM

RING2 RTS +12V output, max.1mA. Connected to input power via 10K ohm resistor.

SLEEVE GND Connected to the system ground and case.

i don't undestand how to connect the RING2.. i need to put one resistor in the cable?

Photo of Don -  ik2egl -  ai4sd

Don - ik2egl - ai4sd

  • 82 Posts
  • 6 Reply Likes
Hi Adriano,let me give you more details (the configuration that I have)

a) on flex/smartsdr configure a CAT cable (see smartsdr cable management section)

b) Station Master JUMPER SETUP : the RS 232 LEVEL is required  (see manual extract and picture below)


b) the CAT connection cable  from RS232 to Station master , see below
Photo of Lorenzo Mendini

Lorenzo Mendini

  • 16 Posts
  • 0 Reply Likes
Nothing to do in microham router? Many thanks
Photo of Don -  ik2egl -  ai4sd

Don - ik2egl - ai4sd

  • 82 Posts
  • 6 Reply Likes
not clear to me, what do you mean for microham router ? what do you need to achieve ?