Flex 6700 scanning

  • 1
  • Problem
  • Updated 6 months ago
I have flex 6700 with V1.11.12.  The radio has been working fine.  I just now sat down at the radio and it is scanning.  I can change step from 1 to 10, 100 etc and it scans at that rate.  I have reset the radio by power down, remove power, reapply power, hold down OK button until counts down to 0 and radio starts.  When radio comes on its on 14.100. Then goes 14.001,14,002,14.003, etc.  I have no memories, no save profiles. I have radio direct connected to computer.  I have tried a different computer. I have unplugged the mouse and keyboard so that there is just radio and computer running ssdr.

If I open a second slice only  one will scan.  This is weird.  I think my radio is possessed. 

Rogerna4rr.
Photo of roger na4rr

roger na4rr

  • 83 Posts
  • 5 Reply Likes

Posted 6 months ago

  • 1
Photo of Larry - W8LLL

Larry - W8LLL

  • 406 Posts
  • 78 Reply Likes
Are you using any third party software that may be causing it?
Photo of roger na4rr

roger na4rr

  • 83 Posts
  • 5 Reply Likes
No third party programs even on the computer.  No other programs at all.  Tried two different computers.
Photo of James Whiteway

James Whiteway

  • 906 Posts
  • 222 Reply Likes
Help Desk time.
Photo of Stan - VA7NF

Stan - VA7NF

  • 419 Posts
  • 96 Reply Likes
Do you have the Flex hand mic and does it continue to scan with the microphone removed?  There have been problems reported with mic caused scanning.