Flex 6700 and WSPR 2.12 - installation problems

  • 1
  • Problem
  • Updated 3 years ago
Setup: Win 7, TX and TX audio via DAX audio channels, latest SSDR.

 On DAX panel RX audio s-meter indicates full strength. Problem- WSPR indicates RX noise at -30 dB , no decoding.
I tried to use IQ audio channel but still no change of signal strength. In SSDR DAX button  and DAX channels are selected. In WSPR Radio is selected as Kenwood TS2000 and I control radio via HRD.

I created a dedicated CAT port for PTT.  TX works fine, but when changing bands on WSPR , frequency changes on WSPR screen, I hear a relay click in Flex but on SSDR panel frequency remains unchanged. On WSPE log I see message:  "set _freq : error= invalid parameter"
Any suggestions how to make WSPR working?

Tom, SP7WT
Photo of Tom

Tom

  • 97 Posts
  • 19 Reply Likes

Posted 4 years ago

  • 1
Photo of Peter Bentley

Peter Bentley

  • 77 Posts
  • 25 Reply Likes

I need help also Tom.

Does nobody out there know how to do this??