Flex 6500 hardware problem?

  • 1
  • Problem
  • Updated 3 years ago
  • In Progress
For the second time, the radio does not start properly. It boots to ready state. but the fans on the side are not running, and when I start SSDR there is no signals. The first time this happened I shut down, did a hard reset and pulled the power for a few moments, then It booted up ok..but now I can't get it to boot properly.
Photo of Bill -VA3WTB

Bill -VA3WTB

  • 4656 Posts
  • 1099 Reply Likes

Posted 3 years ago

  • 1
Photo of Larry - W8LLL

Larry - W8LLL

  • 549 Posts
  • 118 Reply Likes
My first thought is make sure the power poles on the back of the radio are connecting properly, they can loosen up and lower the supplied voltage to the radio. Strange things happen when under volted.
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9478 Posts
  • 3666 Reply Likes
This hardware issue is being handled via the HelpDesk.

This conversation is no longer open for comments or replies.