Flex 6500 and Acom 600s

  • 1
  • Question
  • Updated 3 years ago
  • Answered
I tried with Ddutil, SmartSDR and Omnirig but I can't get communication between 6500 and Acom 600s through RS232. Quite sure it's a problem of configuration/parameters... any idea?
Photo of Stefano - W2WTZ

Stefano - W2WTZ

  • 82 Posts
  • 20 Reply Likes

Posted 4 years ago

  • 1
Photo of np2g

np2g

  • 271 Posts
  • 30 Reply Likes
Official Response
If you choose DDUtility the first page allows you to chose flex or legacy radios. That allows Ddutil to select the proper cat commands. And of course you attach this program to the correct. Cat port. Electronic port.


Doing this correctly will display frequency info.

The next pages on the setup give you access to different amps. Watt meters. Etc.

If it is not listed. You will need to create a virtual com port pair and allow the radio to talk with one port and broadcast to the amplifier port again DDUtility allows you to do this. Also commander will also allow this. (Easier in my opinion)
There is a detailed how to hook up a om amplifier. Using Ddutil. Here in the community pages. Follow that solution. Just do it with the a com.
(Edited)