Flex 6400 footprint

  • 1
  • Question
  • Updated 2 years ago
  • Answered
The Flex 6400 has a pretty big footprint.  Can it be installed on its side with a bit of space below it for airflow?

Photo of Michael Wheatley

Michael Wheatley

  • 29 Posts
  • 4 Reply Likes

Posted 2 years ago

  • 1
Photo of Mike, K7QDX

Mike, K7QDX

  • 28 Posts
  • 14 Reply Likes
Try a FT1000 That's a footprint
Photo of David Decoons wo2x

David Decoons wo2x, Elmer

  • 1585 Posts
  • 353 Reply Likes
There is a vent approximately 1inch wide right behind front panel on both sides and underneath radio. As long as you allow adequate space below the side which will be on the bottom I do not think it will be an issue. The large fan inside will still be in the same orientation so it will not produce any additional force on the fan bearings..

If possible leave 3inch gap on bottom side for airflow.

Dave wo2x
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9478 Posts
  • 3666 Reply Likes
I would have at least 1.5" clearance on the bottom if you orient the radio on it's side