FLEX 6300 will not unkey with V1.6.17

  • 1
  • Problem
  • Updated 3 years ago
  • Solved
  • 1
I currently have a Flex 6300 which has been working perfectly under V1.5.1 but since upgrading to V1.6.17 I find that the transceiver fails to unkey using the new CAT system. I have tried reinstalling the software 4 times now following the release notes, recommendations and best practices and still the same results on every piece of software I have loaded (HRD, JT65 by HB9HQX etc...) Downgrading to the older V1.5.1 cures the problem every time. 

Currently running windows 10 with all the latest updates, anyone seen this before or have any ideas?
Photo of simon Nash

simon Nash

  • 4 Posts
  • 0 Reply Likes

Posted 3 years ago

  • 1
3 years ago
Photo of simon Nash

simon Nash

  • 4 Posts
  • 0 Reply Likes
Official Response
Thanks all for the responses. I have since reloaded V1.6.17 and discovered that the original settings from the older version were being retained and were incompatible with the new version of CAT where CAT control and PTT were being used on the same port.
  • 1

Powered by Get Satisfaction