Flex 6300 and SPE 1k, please help

  • 1
  • Question
  • Updated 3 years ago
  • Answered
hi
I bought a 6300 Flex recently, I can not connect to 'SPE 1k. Using the connection with this cable:

DB- 9 F   <-------------------------------->   DB-15M

Pin 2   RX232 <--------------------------  Pin 9 TX 232

Pin 3   TX 232  -------------------------> Pin 1 RX232

Pin 5   GND  <---------------------------> Pin 4  GND

I connected also the TX on the rear pannel with the relay jack on the SPE 1k rear pannel.

The CAT controll doesn't works, when I change the band the amplifier does not follow the Flex, but when I go on TX with Flex, the frequency is changed on the amplifer. 
How did you have configured the DDutil? My Flex  is connected to the COM  2 port.
Thank You
Photo of Lino Lombardi

Lino Lombardi

  • 20 Posts
  • 7 Reply Likes

Posted 4 years ago

  • 1
Photo of Lino Lombardi

Lino Lombardi

  • 20 Posts
  • 7 Reply Likes
Official Response
Hi 
thanks to all of you for the help, now my Flex is working well with Expert. 
my solution was: 

- DDUtil 3.1.0.17 
- using 232 port on the Expert and 9 pin port on the PC
- enable "signature"  on the feature flag 
- Passive listener: select the com port used by flex 
- Enable SPE 1k and select the com port used by the Esxpert

This is my set up.
Thanks 
Lino