flex 3000 manual calibration how?

  • 1
  • Question
  • Updated 3 years ago
  • Answered
hi 
is it possible to do manual calibration for the frequency of the flex 3000?
condition are poor for wwv and for sure it need to be 59+ to do auto calibration 
so i can hear 14.995.000   for the continue  tone and with a signal generator i have 
i can hear it is about 15hz out so this is why i ask the win of the dds show 0 
any info please ? 
thank you 
elan g0uut
Photo of elan

elan

  • 140 Posts
  • 4 Reply Likes

Posted 3 years ago

  • 1
Photo of John

John

  • 435 Posts
  • 33 Reply Likes
The manual does tell you how to do this on page 106 - 107 of the flex 3000 user manual. You can download the manual from the flex radio downloads link
(Edited)
Photo of elan

elan

  • 140 Posts
  • 4 Reply Likes
well i seen this however it is signal generator  very good i have my own one that is well made 
by R&S  so this was not my question 
if any one can tell me how can i turn 19hz so it can be spot on 
thank you kind
Photo of John

John

  • 435 Posts
  • 33 Reply Likes
Is the f3000 off by 19hz ? It should make no difference if you use wwv or a signal generator as long as the signal generator is accurate. You will follow the same steps on page 107 and you can use any wwv frequency 5,10,15 or any other freq such as 9.00000 Mhz or 13.00000 Mhz etc on the signal generator. Anyone from flex to comment
(Edited)

This conversation is no longer open for comments or replies.