Feeding the audio output of multiple sliced to the input of a software modem.

  • 2
  • Question
  • Updated 1 year ago
I am trying to set up multiple slices on a 6k series Flex that will allow the routing of the audio outputs to the input of a software modem.  This is for an ALE broadcast that occurs on sequentially by frequency.  I use a broadband antenna and would like to do it without manual intervention
Photo of W4NTG

W4NTG

  • 9 Posts
  • 1 Reply Like

Posted 1 year ago

  • 2
Photo of Rudy HB9MHB

Rudy HB9MHB

  • 11 Posts
  • 0 Reply Likes

I am using PCALE with my Flex 6700 and scanning the Frequencies in one Slice with problems, sometimes the Mode changes from USB to LSB on the lower Bands (3 and 7 MHZ). So I need only one Slice. I am not sure if this is a bug in the Smart-SDR software.

Rudy HB9MHB

Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9148 Posts
  • 3466 Reply Likes
It is a deficiency in the PC-ALE software.  It needs to issue a MODE command after each band change for the FLEX-6000.
Photo of W4NTG

W4NTG

  • 9 Posts
  • 1 Reply Like
Tim, do you have any ideas on my original request...tnx Dick
Photo of Bill W2PKY

Bill W2PKY

  • 451 Posts
  • 79 Reply Likes
How about turning on all the speaker channels and take a wire from the radio back into the mic input?
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9148 Posts
  • 3466 Reply Likes
Photo of Ria - N2RJ

Ria - N2RJ, Elmer

  • 2254 Posts
  • 879 Reply Likes
VoiceMeeter banana? Virtual audio cable?
VAC is more or less a staple of Flex users prior to the signature series. 

Ria
Photo of Dick McNutt

Dick McNutt

  • 1 Post
  • 0 Reply Likes
Tnx Ria, is it capable of  more than two links...Dick
Photo of W4NTG

W4NTG

  • 9 Posts
  • 1 Reply Like
Tnx Tim, working through them...Dick