F6300....Key (CW) from the rear, instead of the front?

  • 1
  • Question
  • Updated 4 years ago
  • Answered
Is there a way to run my keyer (Brown Bros)...or straight key, from the 6300's rear panel instead of the front?
   
Thanks, Tom 


Photo of Tom

Tom

  • 47 Posts
  • 6 Reply Likes

Posted 4 years ago

  • 1
Photo of Jim K4JAF

Jim K4JAF

  • 340 Posts
  • 91 Reply Likes
Yes, you can wire it into the accessory jack on the rear.  It is the DB-15 connector.  I don't remember the correct pin out but look at the Flex 6000 hardware manual on the web site.  73s Jim K4JAF
Photo of Al K0VM

Al K0VM, Elmer

  • 582 Posts
  • 94 Reply Likes
Official Response
Tom,
  On the ACC connector Pin 4 is CW KEY/FSK/INT... Pin 5 can be used as ground..

AL, K0VM
Photo of Scott AC8DE

Scott AC8DE

  • 34 Posts
  • 16 Reply Likes
Holy Cow Batman!  I didn't realize that the whole time.  So I can use my external keyer and plug my iambic paddles into the keyer and wire that into the DB-15.  Nice.

This conversation is no longer open for comments or replies.