Ethernet/WI FI not working together after latest update of SDR software

  • 1
  • Question
  • Updated 4 months ago
For the past 4 months, no issues with the Flex 6400 connected to the Ethernet port on my Laptop while I used the internet thru my WI FI card .... After the latest update everytime I try to use the internet it locks up the Flex screen and compiles a bunch of noise through my sound card to the speakers. 

Anyone else have any problem with this? I wish I never would have went for the software update, now when I try to revert back to the previous software the condition continues. 

Thanks. 
Photo of Kevin Darrah

Kevin Darrah

  • 32 Posts
  • 5 Reply Likes

Posted 4 months ago

  • 1
Photo of Bill -VA3WTB

Bill -VA3WTB

  • 3980 Posts
  • 969 Reply Likes
did you do the factory reset? for starters after install?
(Edited)
Photo of Kevin Darrah

Kevin Darrah

  • 32 Posts
  • 5 Reply Likes
Yes.... I did the factory reset.... followed the directions to a T to revert back to the previous software 
Photo of Bill -VA3WTB

Bill -VA3WTB

  • 3980 Posts
  • 969 Reply Likes
This is not a common problem people are having with the update.
Check you ethernet connections and reset your modem.
Photo of Kevin Darrah

Kevin Darrah

  • 32 Posts
  • 5 Reply Likes
Already did... Used a new CAT 7 cable ... Same result. Time too open up a help desk ticket I guess.
Photo of Bill -VA3WTB

Bill -VA3WTB

  • 3980 Posts
  • 969 Reply Likes
They will get you going...