EQ monitor?

  • 1
  • Question
  • Updated 2 years ago
  • (Edited)
Has there been any change to how we hear our TX audio EQ, post or pre?
Photo of Bill -VA3WTB

Bill -VA3WTB

  • 3002 Posts
  • 660 Reply Likes

Posted 2 years ago

  • 1
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9152 Posts
  • 3478 Reply Likes
No, there has been no change.  And none is planned for the near future.  We do not pass the MON signal through the EQ filter bank to minimize latency so you hear transmitted audio in as close to real-time as possible.
(Edited)
Photo of Ken - NM9P

Ken - NM9P, Elmer

  • 4025 Posts
  • 1248 Reply Likes
If you want to test your audio to hear exactly what it sounds like, either

1) use the inboard record and playback, or
2) use the full duplex monitoring technique. (But you must transmit into XVTR port, or use very low power, and listen on a different antenna.). This is good for testing, but you cannot monitor full time this way.

The delay you hear is just about the same delay you would hear if they ported the MON through the filter, PROC, and RX EQ.