DXLAB suit and 6500

  • 1
  • Question
  • Updated 4 years ago
  • Answered
looking for some one and one  help getting  DXLAB suite going with 6500
windows 7  and smartsdr 1.2 
pse email wb5aaa at arrl dot net

Photo of jim WB5AAA

jim WB5AAA

  • 41 Posts
  • 4 Reply Likes

Posted 4 years ago

  • 1
Photo of Reggie-k6xr

Reggie-k6xr

  • 413 Posts
  • 32 Reply Likes

I'm using DXlab with my 6500 at the moment. In commander select com4, 3800,8, n, 1, in config-ports.

select sdr-6500 for the radio.  any question- k6xr@mac.com



Photo of Reggie-k6xr

Reggie-k6xr

  • 413 Posts
  • 32 Reply Likes
should be 38400 baud rate..
Photo of George Molnar, KF2T

George Molnar, KF2T, Elmer

  • 1561 Posts
  • 552 Reply Likes
Of course, SmartCAT must be running and have the virtual pair match your Commander selection. Make sure you uninstalled, rebooted, then installed CAT if upgrading from an older version.
Photo of jim WB5AAA

jim WB5AAA

  • 41 Posts
  • 4 Reply Likes
thanks  to RAY  K9DUR   it is fixed  until I  mess it up agn ..

thank U  RAY