DSP Settings Lost When Mode is Changed

  • 2
  • Question
  • Updated 2 months ago
  • Answered
  • (Edited)
DSP settings are lost whenever the modulation mode is changed.  For example, in CW mode I set NR and APF, I switch to USB, and then I switch back to CW mode only to find that have to set NR and APF again.  I expect those settings to remain set for each mode I operate with.

Am I doing something wrong?  Is there a way to set the default settings to be the settings that I prefer?

In advance, thanks for your info and help!
Photo of Greg, N6GD

Greg, N6GD

  • 6 Posts
  • 0 Reply Likes
  • frustrated

Posted 7 months ago

  • 2
Photo of K1UO - Larry

K1UO - Larry

  • 731 Posts
  • 119 Reply Likes
Official Response

The answer to your problem is to use the "profiles" feature of your radio, create the settings you prefer in the CW portion of the Band and then save that profile as , for example , "20M CW".  Then go to the Phone portion of the Band and set up your receiver with all the settings you prefer on SSB and then save that setup in profiles as "20M SSB"  (don't forget to set up your MIC and TX profiles while you are at it.)

You can do this on a per Band basis or just as a generic profile setting for CW,  SSB, RTTY or any Mode you use and when you want to use that "MODE" of operation just go to profiles, select the MODE  or BAND of operation you want to use and "load" that profile.

I would suggest RTM to familiarize yourself with how profiles can become your friend.   This ,of course, is not the only way to accomplish quick Mode or Band changes.  Some 3rd party Loggers and interface programs allow limited but faster Band or Mode changes without affecting other Flex radio settings.

(Edited)