DAX, Parallels, and fldigi

  • 1
  • Question
  • Updated 10 months ago
  • Answered
I have the latest version of Parallels - v13, latest version of fldigi - 4.0.12, and the latest version of SSDR - 1.11.12.  Everything sets up fine, however, I am not getting any audio stream to fldigi.  fldigi follows the frequency and I can key the radio from fldigi and I do get the TX stream and output into a dummy load.  I am using dax channel 1.  There is audio on the RX stream but nothing in fldigi.  I am sure it is something simple but not sure what.  This same setup works fine on a stand alone PC.

Don - kx9q


  


Photo of Don - kx9q

Don - kx9q

  • 417 Posts
  • 18 Reply Likes

Posted 10 months ago

  • 1
Photo of Bob G   W1GLV

Bob G W1GLV

  • 652 Posts
  • 109 Reply Likes
 Is DAX on in the transmit panel of SmartSDR?
Photo of Don - kx9q

Don - kx9q

  • 417 Posts
  • 18 Reply Likes
Yes


Photo of Don - kx9q

Don - kx9q

  • 417 Posts
  • 18 Reply Likes
The other thing I noticed when I looked into the Sound Playback and Recording (windows) only the DAX RESERVED AUDIO RX 1 showed any activity on receive which would be the Playback section of the Sound window which I assume is actually the transmit. On the recording side there was no activity at all on receive.

Don - kx9q

Photo of Don - kx9q

Don - kx9q

  • 417 Posts
  • 18 Reply Likes
When all else fails remove SSDR, DAX, CAT, FlexVSP then reboot and reinstall.  All works fine now.

This conversation is no longer open for comments or replies.